Instructions / Assembly
Step 5: Place panel on the wall, leaving space and the joints for expansion and contraction.
Expansion Joint Recommendations
i
nstallation of panels over 12’ long is not recommended
PANEL SIZE 4X8 4X9 4X10 4X12
G
a
p
a
t
c
e
i
l
i
n
g
1
/
4
”
1
/
4
”
3
/
8
”
3
/
8
”
G
a
p
a
t
f
l
o
o
r
1
/
4
”
1
/
4
”
3
/
8
”
3
/
8
”
G
a
p
b
e
t
w
e
e
n
p
a
n
e
l
a
n
d
c
e
n
t
e
r
o
f
1
p
i
e
c
e
m
o
l
d
i
n
g
1
/
8
”
1
/
8
”
3
/
1
6
”
3
/
1
6
”
G
a
p
b
e
t
w
e
e
n
p
a
n
e
l
a
n
d
c
e
n
t
e
r
o
f
2
p
i
e
c
e
m
o
l
d
i
n
g
1
/
4
”
1
/
4
”
3
/
8
”
3
/
8
”
G
a
p
b
e
t
w
e
e
n
p
a
n
e
l
n
o
t
u
s
i
n
g
m
o
l
d
i
n
g
1
/
4
”
1
/
4
”
3
/
8
”
3
/
8
”
Failure to allow adequate molding spacing may cause delamination
Divider Bar
Incorrect
Correct
Step 6: Use of silicone sealant is recommended to achieve a moisture resistant installation. Place silicone
sealant into the channel of cut-to-size moldings. Fit coordinating moldings between the joints leaving the
recommendations in step 4 to allow for expansion and contraction.
In high moisture and frequent wash-down areas, silicone should be used between moldings and
floors/ceilings to prevent moisture from penetrating the back of the panel substrates.
Step 7: Use a laminate roller to remove air pockets. Work from the middle of the panel out to the leading
edge.
Step 8: Repeat steps one through seven until project is complete.
Step 9: Clean excess adhesive residue from surface of panels following adhesive manufacturer’s
recommendations.
285 Industrial Drive
Moscow, TN 38057
Phone: (901) 877-3010
Fax: (901) 877-1388
www.glasteel.com
DISCLAIMER and LIMITATION of Liability: The information contained
in this literature is presented in good faith, and is believed to be
accurate and reliable at time of publication. No representation,
guarantee or warranty is made as to the completeness, reliability or
accuracy of this information. This also includes NO IMPLIED
WARRANTY OR MERCHANTABILITY OR FUNCTIONAL USE FOR
SPECIFIC APPLICATION.
Cleaning Instructions
Glasliner FRP Panels are designed for minimum care and
maintenance. When cleaning panels, wash with light detergent
such as Spic & Span, Pine Sol, Mr. Clean, etc. Panels may also be
cleaned with steam, high pressure sprayers, or soap and water. It is
strongly recommended not to use abrasive cleaners on panels (i.e.,
SOS Pads, Ajax, Comet, etc.). Following these instructions,
Glasliner FRP Panels will give a fine and lasting appearance for
many years.
12/11
M0411