User Manual

3. HOW DOES IT WORK?

Locate your A/V device in a closed cabinet or TV unit. The IR receiver (1) must be located

in view of your remote control. Stick the IR LEDs (2) on the front panel of your A/V

equipment and then hide the IR main module (3). Point the remote control towards the

small IR receiver in order to send the desired command (via the IR module) to the IR

LEDs; these will then send on this infrared command to the A/V equipment.

4. INSTALLATION

In order to check that the system works correctly, it is advisable to first test the set-up

you had in mind. To do so, connect everything as described below but do not stick the

components securely.

4.1 LOCATING THE IR RECEIVER

Place the very small IR receiver (1) that comes with the Invisible Control6™ so that it can

be seen by your (infrared) remote control and receive the commands (max. 10 metres).

• The most logical location for the IR receiver is, for example, on the cabinet in which

the A/V equipment is located or near the TV.

• You can run the cable underneath or behind, using the notch at the back of the IR

receiver housing; this allows the cable to be hidden easily.

• Use the self-adhesive strip which is supplied to locate the IR receiver just about

anywhere you please.

• Experiment with the location before you stick the IR receiver in its final position.