User manual

Video DoorPhone 210
11
ENGLISH
Auxiliary terminal
These two terminals act like a switch and will be short circuited as long as
the doorbell button (1) is pressed, however, there is no voltage supply
from these terminals. They can be used to trigger a conventional door chime
or a courtesy light at the entrance.
Now insert the 3 pcs AAA (UM-4) alkaline batteries into the battery
compartment as this can serve as a battery back-up in case the 12V DC
supply fails.
Install the back of the door unit onto the mounting bracket using the supplied
tool.
The door unit is housed in a high impact ABS/PC cabinet, which can achieve
the professional grade ruggedness required in most outdoor applications.
Rubber gaskets seal around all of the joints keep out dust, rain, snow and
spray, assuring years of reliable operation even in harsh environments. The
unit meets to IP-54 standard and can operate from -20˚C to 50˚C.
OPERATION
ON / OFF
Switch on the handset by a long press (over 3 seconds) of the Power
ON/OFF button (15). (Long press the same button again in case you
want to switch off the unit.)
The power indicator (20) will light up blue. In case the Li battery has run
down, the power indicator will start flashing blue. At the same time, the
battery icon shown on screen (18) will become empty and flashing. Place
the unit into the charger stand to charge up the battery.
To DC supply
and electric
door lock
The connecting wire can
come out from the
opening at
the bottom in case not
concealed in the wall