User manual

Handset

The supplied Li

polymer battery

pack is already

installed in the

handset. (To

replace the battery,

press down and

slide open the

battery door in the direction as shown, take out the battery pack and

disconnect it from the socket.

With the handset

remaining switched off,

place it onto the charger

stand.

Plug in the supplied AC

switching power supply

into an AC outlet and

connect its output plug

to the USB port (21)

located at the back of

the charger stand.

The power indicator (20)

should light up red during the charging process. Adjust the position of the

handset in the charger stand in case this indicator does not light up. During

charging, in case the screen (18) is turned on, the segments within the

battery icon will flash in turn.

The battery pack should be fully charged within 4 hours when used for the

first time. The power indicator (20) will now go off (if the handset is switched

off) or turn steady blue (if the handset is switched on).

Now the unit can be switched on and is ready for operation. Either taking out

the unit or keeping it placed in the charger stand will cause no damage to the

battery. In the latter case, when the battery is being consumed and voltage

falls to a certain level, the charger stand will automatically charge up the

battery.

CAUTION: BE SURE THE BATTERY IN THE HANDSET IS A

RECHARGEABLE TYPE BEFORE YOU PLACE IT IN THE CHARGER

STAND, OTHERWISE AN EXPLOSION MAY RESULT.