User manual

10 © MARMITEK
Figure 4
• Install the wall switch at its original place after the MicroModule
is programmed.
Please note: due to heat generation, apply no more than one module
per flush socket / central socket!
Programming
WA
RNING: DO NOT FORGET TO TURN ON THE MAIN MASTER
SWITCH PRIOR TO PROGRAMMING.
Activate the setup mode.
Th
e following steps have to be taken to start the setup procedure for
programming the MicroModule:
• Press the setup (prog.) button for at least 3 seconds (see figure
5). The LED should stay on after releasing the setup button.
• Warning! The MicroModule will leave the setup mode if it
doesn’t receive any commands within 60 seconds.
Exit setup mode
• P
ress the setup button once shortly; The red LED will turn off
now. You can also wait for at least 60 seconds so that the
MicroModule will exit the setup mode automatically.
prog.
SAIX
prog.
SAIX