Technical data

INITIAL SETUP VIA BLUETOOTH

1. Turn on the BoomBoom150/152 by pressing the POWER

button.

2. Wait for approximately 20 seconds. The speaker will go

into pairing mode and will produce a “beep” tone. The

red & blue lights will then flash alternately.

3. Turn on a device that supports Bluetooth, such as an iPod,

iPhone, Android or mp3 device and go to: Settings >

General > Bluetooth. Click ON the Bluetooth.

BoomBoom150/152 will then appear on the device. Click

ON the BoomBoom150/152. The device is now connected

and paired with the speaker. If the device prompts for a

pair code, enter:”0000”

4. If the pairing failed within 150 seconds, the system will

search for the last paired device and the blue LED will

flash slowly. To restart the pairing process, turn off the

speaker and repeat step 1. If the initial setup connection

is successful, the next time the speaker is turned on, the

speaker will automatically pair to the last device it was

connected with.

! You can link to up to 8 devices however only 1 device can be

connected to the BoomBoom150/152 at one time.

VOLUME CONTROL

1. Tap VOLUME+ for 1 second increments to increase the

volume. When maximum volume has been reached, a

tone indicator will sound.

2. Tap VOLUME- for 1 second increments to decrease the

volume. When minimal volume has been reached, a tone

indicator will sound.

3. Press VOLUME+ for 2 seconds to listen to the next song.

(NOTE:THIS FEATURE MAY NOT WORK WITH SOME BLUETOOTH DEVICES)

4. Tap VOLUME- for 2 seconds to listen to the previous song.

(NOTE:THIS FEATURE MAY NOT WORK WITH SOME BLUETOOTH DEVICES)