Operation Manual

© MARMITEK 6
CONNECTING DEVICES THAT HAVE ALREADY BEEN
PAIRED
Set the ON/OFF switch to the ON position.
The LED status will now light up and stay on, indicating that the BoomBoom
230 is switched on but not yet paired with any Bluetooth device.
Once a Bluetooth device has been paired with the BoomBoom 230, it can be
reconnected to the BoomBoom 230 in two different ways.
1. Switch the Bluetooth device on and select the BoomBoom 230 to make a
new connection. The device is now connected to the speaker.
2. Press the Connect button on the BoomBoom 230 briefly. The BoomBoom
230 will now reconnect with the most recently paired Bluetooth device.
When connected, the blue LED lights will start to flash at a slow rate. Only one
device can be connected at the same time to the BoomBoom 230.
SWITCHING BETWEEN THE LAST 2 BLUETOOTH
DEVICES
You can switch between the 2 most recently paired Bluetooth devices by
pressing the CONNECT button briefly.
! Ensure that the device is switched on and that it accepts Bluetooth
connections.
CONNECTING WITH AN AUDIO CABLE
The Bluetooth connection can be switched to a wired connection by plugging
the cable into the 3.5mm audio jack. The volume and pause key function will
be disabled in the wired connection mode. Simply unplug the 3.5mm audio
jack and press the CONNECT button to revert back to the Bluetooth
connection.