Operation Manual

Note! The sticky strip may lead to discolouration or leave glue residues on certain

surfaces.

4.2 LOCATING THE IR EXTENDER LED

Place the LEDs (2) from the IR extender cable precisely on the IR window (infrared

sensor) on the A/V equipment that you wish to operate.

• Ensure that the IR extender cable’s LEDs are stuck precisely on the A/V device’s

infrared sensor (this can be extremely accurate on some devices). The exact position

can easily be located by shining a torch on the front panel and looking for the IR

sensor window.

• All IR LEDs include self-adhesive film with which they are attached to your A/V

equipment.

• Test the position and the performance of the IR LEDs before you secure them to the

IR window on your A/V equipment.

• If you use just one or two of the three LEDs, you can leave the other IR LED unused.

Never remove it from the extender cable!

4.3 LOCATING THE IR MODULE

Mount the IR Module (3) at an accessible place behind or alongside your A/V

equipment, in the vicinity of an electrical socket.

• Be aware of the cable length of the IR LEDs and the IR receiver.

• Make sure that the connections remain accessible and that the ‘IR data’ light

remains visible so you can check it is working properly.

• Use the self-adhesive strip which is supplied to locate the IR receiver just about

anywhere you please.

ENGLISH

INVISIBLE CONTROL6