Operation Manual

TIP:

• With the help of the supplied IR Extension cables 4 A/V devices can be controlled with

the IR Module, which is simply to be extended to maximal 8 A/V devices with the help of

one ore two optional obtainable IR LEDs. (Art. Nr. 09777).

• With the help of an extra IR Receiver you can also control your A/V equipment from

another place (if desired you can extend the connection cable of the IR receiver.)

- built-in IR receiver Art. nr. 08004

- built-on IR receiver Art. nr. 08003

STATUS CONNECTION (Power adapter not supplied)

You can send a Power Status signal to the IR module by connecting a Power adapter to this

connection (not supplied; 12VDC/200mA), which is switched by the device to be controlled.

When the A/V device or contact is switched in a LED will light up in the IR Module so that

you can see that the A/V device is switched in. (see picture 3).

4. FREQUENTLY ASKED QUESTIONS

The IR Receiver does not respond to signals of my remote control.

Observe the following directions:

• Check the connections, is the power adapter connected to the correct connection? This

must be connected to the ‘POWER’ connection, the green lamp will burn when the

power adapter is plugged in the plug.

• Both the built-in and the built-on IR Receiver has a reception sensibility of about 10

metres at an opening Angle of 90 degrees. Range is also dependent on the remote

control used. The IR reception indication LED in the IR Receiver will light up at reception

of an IR signal.

6 © MARMITEK

V+

Picture 3

Power adapter 12V/200mA (optional)

Circuit power on back

of A/V equipment

230V/50Hz