User`s guide

X10CONFIG(5) X10CONFIG(5)
fully Offthrough fully On and vice-versa. This
allows their use in scripts for controlling things
other than modules.
REMOTE3 -Similar to REMOTE4 except that the On
command is ignored by the state engine except for
addressing the particular unit in the housecode -
it does not change the stored brightness level.
The Offcommand does set the brightness levelto
zero and the Bright and Dim commands makeincremental
changes in this levelwithin the range fully Off
to fully On. (The Bright and Dim signals sent by
RF remotes do not include a unit code. This module
type allows using the On signal to address a
particular unit without changing the stored brightness
leveland then using the Dim and Bright commands for
some analog control purpose via a script.)
REMOTEP -Again not actually a module, but can be
used as a target for transmitters which send only
the Preset (1-32) codes.
SHUTTER (SW10) - Shutter and shade controller
which support Extended Code Type 0 commands. The
Marmitek SW10 Shutter Motor Controller is the only
module known to support these commands and Marmitek
keeps it a secret. This Heyu model supports Extended
Type 0 functions 0x01, 0x02, 0x03, 0x04, and 0x0B.
The Heyu model also supports the standard On and Off
commands, but not Dim or Bright, to which the shutter
module is reported to react in an unpredictable manner.
VDATA -Avirtual module which can store a data
byte as if it were a (raw) brightness level0-255.
Data is written to this virtual module only with the
´heyu vdata HU <data>´ command - it is unaffected
by anyother X10 command.
The following security transmitter models are included for use with RF auxiliary input from a W800RF32A
or RFXCOM receiver.
DS10A -(PDS01) X-10 DS10A Security Door/WindowSensor
DS90 -(DS18-1) X-10 DS90 Sec Door/WindowSensor (2 chan)
DS18-1 -()ElekHomica DS18 Sec Door/WindowSensor (2 chan)
DS18 -()ElekHomica DS18 Sec Door/WindowSensor (1 chan)
MS10A -(PMS01) X-10 MS10A Security Motion Sensor (See section "MS10A WARNING" in man page
x10aux(5))
SH624 -(PSR01) X-10 Security Remote
KR10A -(PKR02, KR21) X-10 Security Keyfob Remote.
KR18 -(KR18E) Marmitek Security Keyfob Remote.
SD10 -()Marmitek SD10 SmokeDetectors
SD90 -()Marmitek SD90 SmokeDetectors
BMB-SD18 -()BMB SD18 SmokeDetector
MS90 -(MS18E) Marmitek MS90 Security Motion Sensor
EH-CWSD10 -()ElekHomica EH-CWSD10 SmokeDetector
local 5