Operation Manual

6 © MARMITEK
Remote control
[13] Stand-by button
[14] Automatic frequency tuning button “Tune”
[15] Volume button “+ / - “
[16] Atmospheric lighting on/off button “Light”
1. Open the battery cover at the back and place the enclosed “AAA” alkaline batteries to
activate the remote control.
2. Point the remote control at the front of one of the speakers and press one of the buttons
to operate the speaker.
OPERATION
Switching ON
1. Turn on the audio source (TV, PC, Radio, CD-/MP3-/MP4-/DVD player) to which the
transmitter is connected. The signal LED [3] on the transmitter will light up (Blue).
2. Adjust the volume to the level you desire by pressing the Volume button on the speaker [9]
or on the remote control [15] or turning the volume button of your audio source.
Tip:
- For crystal clear sound, put the volume of the audio source higher and adjust the
volume of the speakers to the desired level.
- Place the speakers on the floor for the best possible sound. Different bases can
influence the sound quality. Experiment at different places to determine the best
sound quality.
3. For the best audio reception, you need to tune the set. Therefore put the speakers and
transmitter together (max 7meters in-between). Push the “AUTO TUNING” button on the
speaker [8] or the remote control [14].
Whenever you find frequency jam, move your channel switch from one channel to the other
channel (there are three channels for selection) on the back of the transmitter, and then press
the “AUTO TUNING” button [8/14] on the speaker again.