Operation Manual

6. Operating the receiver

As soon as a valid transmitter signal is received by the receiver, the

receiver will output the amplified audio signal to the speaker

outputs. You can change the audio level by adjusting the receiver

volume control.

In order to achieve maximum transmission quality, the transmitter

volume control should be set to match the audio level of your audio

source as follows:

1) Set the receiver volume control to a low level to prevent clipping

inside the receiver.

2) Set your Home Cinema Set to output the maximum audio level that

you will encounter during normal operation.

3) Turn the transmitter level control knob to the position that yields

maximum audio loudness to the speakers without any clipping

(distortion). If the transmitter level is set too low, the dynamics of the

transmission are not fully used. If the level is set too high, audio

clipping (distortion) will occur inside the transmitter.

4) Turn the receiver volume control to a setting that yields the desired

volume from the speakers.

If no audio signal is received for more than 30 minutes, the receiver

will go into standby mode (power-down mode).

Receiver

volume

control

DC 24V

SPEAKER OUTPUTS