User's Manual Part 1

mida
71
10. PROGRAMMING THE SYSTEM
Hold down the “Enter” key for longer than 2 seconds to switch the system to programming mode. Then select the type of programming
with the “Select” key:
 I --> Interface Programming
 P --> Transmitter Programming
 r --> Transmitter Programming in "Recovery" mode
 rSS Æ Programming the “Sniffer” function
When you have made your selection, use the “Select” and “Enter” keys to edit the programming data. The “Select” key increases the
current programming data item, whilst the “Enter” key confirms it and goes to the next item.
CAUTION: If you want to reprogram only the Operating channel, start the procedure from transmitter programming.
In this way, since the interface is supplied with the Automatic channel programming function enabled (AP=1 – see sec.
10.1 “Programming the interface” on page 72) when transmitter operating channel reprogramming is complete, the
interface is also automatically programmed on the same channel.
TRANSMITTER
PROGRAMMING
INTERFACE
PROGRAMMING
TRANSMITTER
PROGRAMMING IN
RECOVERY MODE
> 2 seconds
PROGRAMMING THE
“SNIFFER” FUNCTION