User's Manual Part 1

mida

10.2 Programming the Transmitter

Switch to programming mode and select the type of programming "P" with the “Select” and “Enter” keys to edit the following values one

at a time:

Note:

after confirming the last data item you exit programming and the transmitter is deactivated.

However, you can exit programming at any time, by holding down the <ENTER> key for longer than 2 seconds, cancelling

the current sequence.

(

∗

)

Note:

depends on the type of transmitter:

- for a transmitter with radio activation, the activation mode parameter is set to radio activation and the switch off time

value is <5>, corresponding to 2'14"

- for a transmitter with mechanical activation, the activation mode parameter is set to mechanical activation and the

switch off time value is <8>, corresponding to an infinite switch off time.

Channel entry:

TENS

Channel entry:

UNITS

Identification code:

(A, B, C, D)

ctivation mode:

0= Radio

1= Mechanical

Operating time:

0= 4"

1= 8"

2= 17"

3= 34"

4= 1'7"

5= 2'14"

6= 4'28"

7= 8'57"

∞

Timer Rettriggering:

0= Disabled

1= Enabled

Confirm data programmed:

0= do not confirm

1= confirm

> 2 seconds