User's Manual Part 1

ENGLISH
E86N- Touch system with radio transmission
82
12. FITTING THE TRANSMITTER
12.1 Fitting the Standard transmitter on the taper
- Remove the transmitter battery covers (C) - screws (D) – to gain access to the four holes (E) on the flange. You can fix the
transmitter with a standard flange in two different ways:
- Make four threaded holes M4x8 (A) and a central countersunk area (B) in the taper, as illustrated in Figure 12-1.
- Insert the ø6 mm ball (G) supplied between the transmitter and the taper.
- Secure the transmitter to the taper with the four screws (F).
Aligning the system
- Fit the probe finger (see "Fitting the probe finger").
- Align the centre of the finger ball with the taper axis using the four screws (F).
- When the system is aligned, tighten the four screws (F) in a cross sequence.
Figure 12-1
F
E
D
C
D
C
F
34
(1,34”)
34
(1,34”)
4,5
±
0,1
mm
(0,177 ±
0,004
)