Operation Manual

GB
Troubleshooting
Before going through the checklist please make all the connections fi rst. If you
still have questions after going through the checklist, please consult your local
customer service representative.
Fault Symptoms Cause Solution
CDs are drawn only half way into
the CD tray.
The transport screws have not
been removed.
Remove the transport screws.
ERROR 2 is shown in the
display.
The CD is inserted the wrong
way round.
Insert the CD right way round.
CD cannot be selected using the
MOD button.
There is no CD inserted. Insert a CD.
After being inserted into the
device the CD or cassette does
not turn.
The volume control is set too
low.
Turn up the volume.
The device has not been correct-
ly connected.
Check the +12V and earth
connection.
CD works intermittently
(dropouts).
The surface of the road is
uneven.
Wait until the road becomes
smoother before playing the CD.
The device is not fi rmly installed.
Install the device fi rmly.
Ensure that the rear attachment
is used if the vehicle does not
have any suitable retainer for the
rear section of the device.
The CD is damaged.
Try another CD. If this works
correctly, the fi rst CD is probably
damaged.
The CD is dirty. Clean the CD.
The device may have been
installed in the vehicle at the
wrong angle.
Please note that a maximum
inclination of 20° degrees should
not be exceeded!
No function.
The ignition is switched off.
Turn the ignition key to „ON“ or
„ACC“.
One or more fuses have blown.
Replace the fuse by another
10A /0,5A/1A fuse.
Device cannot be switched on or
off via the ignition.
Incorrect connection (each
car manufacturer wires the
ISO connection in the vehicle
differently).
Please contact your car
workshop or a vehicle specialist
for connection adapters may
specifi cally for your model.
The device does not work cor-
rectly (EJECT, LOAD, PLAY).
The microcomputer has been
interfered with by electromag-
netic fi elds.
Remove the CD or cassette and
reinsert it.
Switch the device off and on
again.
E14