Installation Guide

10
11
12
FIGURE 5B
4 Set the bottom rail to the side. Position the bracket at marked location and secure
using two of the screws provided in the Marquee Stair Bracket Kit. Use 2" screws
when mounting to a wood post or the 1-1/4" screws when mounting to Marquee
Post Mount. Repeat on post at opposite end of rail section.
5 Insert bottom rail into the brackets, making sure the rail is level at desired angle.
Secure the bottom rail in place by installing two self-drilling 1" screws provided in
the Marquee Stair Bracket Kit on each side of the brackets. Repeat on post at
opposite end of rail section. (Fig. 4)
6 Insert a baluster into the first and last pre-routed holes of the bottom rail, making
sure each one is fully nested. Align the top rail over the balusters and install into the
pre-routed holes, with the notched end of the rail at the upper end of the stair
section. The rail should extend past the post sleeves on each side. Use a level on
the balusters to ensure they are vertical. (Fig. 5) Mark both ends of the rail where
they cross the post sleeve.
NOTE: Because the pre-routed baluster holes are
angled, be sure the notched end of the top rail
is on the upper end of the rail section. This is
opposite of the bottom rail.
7 After the top rail is properly marked, remove it from the stair section and cut the
top rail.
8 Install the remaining balusters into the pre-routed baluster holes on the bottom rail,
making sure each one is fully nested.
9 Align the top rail over the balusters and install one at a time into the pre-routed
holes. Ensure the top rail is fully nested and level with the bottom rail at the desired
angle. Position the top rail brackets on the rail, center the bracket on the post and
mark the bracket locations on each post. (Fig. 6)
Remove the brackets from rail. Tilt the rail outward from the post slightly to expose
the face of the post. Reposition the top rail brackets at the marked locations on each
post and install with screws provided in the Marquee Stair Bracket Kit. (Fig. 7)
Use 2" screws when mounting to a wood post or the 1-1/4" screws when mounting
to Marquee Post Mount. Repeat on post at opposite end of rail section.
Slide the top rail into the top rail brackets and secure in place by installing two self-
drilling 1" screws provided in the Marquee Stair Bracket Kit on each side of
the brackets.
Attach the post cap using PVC adhesive (not provided).
FIGURE 5
FIGURE 6
Fig. 5
Fig. 6
Fig. 7
FIGURE 7
6
FIGURE 4
Fig. 4