Owner`s manual

CAUTION! Exposing too much wire or having wires
with frayed ends could cause wires to touch each
other, which could damage the equipment.
3. Wire connections
A. Red = Right (+)
B. Black = Right (-)
C. White = Left (-)
D. Green = Left (+)
NOTE: Do not connect speaker cord to any speaker
terminals already in use.
4. Check all connections to the stereo receiver.
Make sure all wires are connected in phase
(+ to + and – to –). Correct any wiring problems
before reconnecting the stereo receiver to the
power source.
You should perform a routine inspection (every
three months) of the Soundsations Audio System
to ensure that the system is operating properly.
If the cord or cord-connection is damaged; if the
door to the equipment compartment shows signs
of deterioration; if excessive water is entering the
equipment compartment; or if there are other signs
of damage to related components, turn off the spa
and have the damaged component repaired by a
qualified service person.
Recommended components
Use stereo receivers rated from 60 to 120 peak
watts per channel and rated from 8 to 16 ohms.
The Soundsations Audio System has automatic
protection circuits to protect against overload. This
circuit activates at high volume levels to reduce
output, causing a decrease in volume. This is
normal operation and indicates that the power
input may be exceeding safe levels. If this
protection circuit has been activated, turn down
the volume to allow the system to reset itself and
resume normal operation. Sustained listening at
high volume settings is not recommended.
CAUTION! Please read this installation guide
completely before the installation. Failure to follow
the instructions in this guide voids all warranties on
the Soundsations Audio System.
Wire connections.
perfect fit!
spa control operation
27
RED
BLACK
WHITE
GREEN
R
L
+
+
-
-