Owner`s manual

perfect fit!

FAILURE TO GET A SANITIZER READING ON

TEST STRIP

C: Sanitizer level is too low.

S: Add chlorine or bromine until the sanitizer

registers in the recommended range on the

test strip.

C: Algae present.

S: Dirty water consumes the sanitizer as soon as

it is added. Add more chlorine or bromine until

the sanitizer registers and stays in the recom-

mended range on the test strip.

C: Test strip remains “white” even after sanitizer

has been added.

S: Sanitizer level is extremely high. It can bleach

the reagents on the test strip and give a false

reading. (See below.)

TOO MUCH SANITIZER IN THE WATER

C: Too much chlorine or bromine added or

dispensed into the spa.

S: Remove spa cover and activate jets and air

control. Allow jets to run for 30 minutes. Test

water with a Water Test Strip to see if desired

level has been reached.

EYE OR SKIN IRRITATION

C: Contaminants or excessive amount of

chloramines/bromamines in water.

S: Treat water with Shock. Adjust sanitizer level.

C: pH level is low.

S: Adjust pH level as needed.

CORROSION OF METAL

C: Low pH level.

S: Adjust pH level with pH and Alkalinity Up.

GREEN WATER/ALGAE

C: Low sanitizer level or high pH.

S: Adjust pH and sanitizer as necessary.

ERRATIC pH TEST COLOR

C: Sanitizer level is too high. (See TOO MUCH

SANITIZER IN THE WATER.)

S: Test pH again when sanitizer level is below 5 ppm.

spa care and enjoyment guide