Owner`s manual

SETTINGS
Clock
Press the CLOCK pad followed by the SETTING pad.
“Program” will be shown in the upper left corner of the
panel display and the hour will begin flashing. To adjust,
press the TEMP+ or TEMP- pad. Once the correct hour
has been set, press SETTING pad to set the minutes.
“Minutes” will flash. Follow above procedure to set the
correct minutes.
Filter Cycle 1:
Press the CLOCK pad followed by the SETTING pad
three times to enter Filter 1 programming. “Program
filter 1 start time” will be shown in the upper left corner
of the panel display and the hour will begin flashing. To
adjust, press the TEMP+ or TEMP- pads. Once the
correct hour has been set, press SETTINGS pad to set
the minutes. Follow above procedure to set the correct
minutes. Press the SETTING pad again and “Program
filter 1 end time” will be shown in the upper left corner of
the panel display and the hour will begin flashing. Follow
above procedures to set the correct hour and minutes.
NOTE: When in a filter cycle the Filter Cycle LED will
illuminate.
Filter Cycle 2:
Press SETTING pad to enter filter 2 programming
mode. “Program filter 2 start time” will be shown in the
upper left hand corner of the panel display and the hour
will begin flashing. Follow above procedure to set the
correct hour and minutes. Press the SETTING pad
again and “Program filter 2 end time” will be shown in
the upper left corner of the panel display. Follow above
procedure to set correct hour and minutes.
Spa Light:
Press SETTING pad to enter spa light programming
mode. The light icon will begin flashing at the bottom
of the panel display. “Start time” will be shown in the
upper left hand corner of the panel display and the
hour will begin flashing. Follow above procedure to set
the correct hour and minutes. Press the SETTING pad
again and “end time” will be shown in the upper left
corner of the panel display and the hour will begin
flashing. Follow above procedure to set the correct
hour and minutes. Press the CLOCK pad to exit the
programming mode.
NOTE: Any time during the setting of features you may
exit the programming mode by pressing the CLOCK pad.
If you do not want to run any of the filter modes or spa
light cycles, set the start and end times for the same time.
SPA CONTROL OPERATION
47