Owner`s manual

HEAT MODE
Your spa comes preset in the standard heat mode.
Allow 12-24 hours for the heater to achieve your
desired water temperature.
The heat mode can be adjusted to one of three
different settings:
Standard Mode
The spa water heats as necessary to maintain the set
temperature. “Standard” will display until the mode is
changed. NOTE: The last measured temperature
displayed is current only when Pump 1 has been
running for at least two minutes.
Economy Mode
In this mode the spa only heats to the set temperature
during a filter cycle. The “Economy” icon will display until
the mode is changed. Press the JETS 1 pad to put the
spa in “Standard-in-Economy” mode which operates
the same as Standard mode (both Economy and
Standard will display). The spa reverts to Economy
mode automatically after one hour.
Sleep Mode
The spa water heats to within 20°F (7°C) of the set
temperature only during filter cycles. “Sleep” will display
until the mode is changed.
To Adjust Heat Mode
First press the SETTINGS pad. The current heat mode
will start flashing. Use the TEMP- pad to scroll through
the modes. When desired mode is displayed touch
the SETTINGS pad again to lock the mode.
Panel Lock
Press TEMP+ or TEMP- pad followed by QUIET SOAK
pad to lock. Then press TEMP+ or TEMP- pad followed
by QUIET SOAK pad to unlock.
• Lock feature locks all user settings: time, filter
cycles, heat modes, SmartClean™ and
temperature settings.
• Lock feature does not lock Jets 1, Jets 2, Timer,
Spa Light, Waterfall Light, Quiet Soak, or Clock.
• Secured LED will illuminate when system is locked.
SPA CONTROL OPERATION
48