Owner`s manual

P: pH is low.

S: Adjust as needed.

Corrosion of Metal

P: Low pH.

S: Adjust pH with pH and Alkalinity Up.

Green Water/Algae

P: Low sanitizer level or high pH.

S: Adjust pH and shock as necessary.

Erratic pH

P: Alkalinity and/or calcium hardness are too low causing pH “bounce”.

S: Test and adjust alkalinity and/or calcium hardness to bring them into the ideal

range.

DURAWOOD STEP INSTALLATION (OPTION)

The DuraWood step and mounting brackets may be placed along a straight side

of the spa, most often centered to the entry location.

Find the center of the spa side where you want to mount the step. Measure

27.5” center spread and mark. Measure 1” up from base and mark.

• With step mounting brackets facing outwards, mark the two holes.

• Using the bracket as a guide, predrill two holes per bracket.

• Attach the left and right brackets to the spa exterior base.

• The step hardware is factory-installed. Loosen the thumbscrew. Gently push

step towards the spa until the brackets and hardware engage.

• Tighten the thumbscrew to attach the step to the spa exterior.

NOTE: All steps can be inherently dangerous. Always use caution in stepping in

and out of your spa.