User Guide

Quick Start Guide - Cube Dehumidiers
ie
OPERATING INSTRUCTIONS
Power Button
(connect)
Up/Down
Fan Button
and Indicators
(reset filter)
Mode Button Filter Indicator
LED DisplayBucketless
Indicator
Timer Button
and Indicator
Fill Level
Button and
Indicators
Network
Connection
Indicator
ie
Connect:
Holding the power button for 3 seconds will
place the unit in network connection mode
to setup wireless control.
Fill Level Button:
Press this button to change the required
water level before the bucket full switch
activates. For more information about each
fill level, see page 10 of the full user manual.
Bucketless mode:
1. Press and hold the up and fill level
buttons for 3 seconds until the bucketless
icon appears on the display.
2. Ensure the dehumidifier is on flat level
ground (free of debris).
3.
4. Attempting to change the unit into
bucketless mode while it is sitting on the
bucket will have no effect.
To remove the unit from bucketless mode,
place the unit back on the bucket.
Fig. 4
Fig. 5
Bucketless mode allows you to run the unit
without the bucket in place. The included
drain hose or a garden hose must be
attached for proper bucketless mode
operation. Please refer to fig. 4 & fig. 5, the
drain hose must be properly sloped to the
drain. To activate bucketless mode, the
following steps must be completed within
three minutes of plugging the dehumidifier in.
Make sure the hose for Bucketless mode
is sloped down to the drain and does not
rise above the connection point