Product specifications

CashFlow
®
9520 / 9524 / 9528 Design Guide
©
MEI., 2003 Page 18 Rev: G1
Automatic Mode - Parallel or BCO Selection
In this mode the status of the output mode input (on pin 8 of the 17-way connector, or pin 7
for the 15 -way connector of the machine interface) selects either the parallel or the binary
coded output interface standards.
A logic high signal to this pin will select parallel mode, setting pin 8 to a logic low will select
BCO mode. If there is no connection made to pin 8 the interface will default to parallel
mode.
Mechanical
Interface connections are via a 17-way header from the standard PCB. This header is single
row of 17 pins on a 0.1 inch x 0.1-inch grid, with a pin size of 0.025-inch square. The
complete interface connector (connector 1) functions are shown on the next page.