- Marshall Electronics Home Security System Specification Sheet

Marshall Electronics
Use the DV-Power pack (V-DV-PWR1) with Marshall Electronics line of Stand Alone monitors. This product is the
perfect solution for users of DV and HDV Camcorders and allows you to standardize on one type of battery for a
wide range of applications.
1
Product Overview
2
Features
• Designed for users of DV and HDV cameras
• Includes V-Mount adapter for use with Marshall Stand Alone Models
• Charge from Monitor Power source, car battery, or optional charger.
• Monitor may be operated while batteries are charging
• 3 Stage Power Indicator
• Charge Status Indicator
• 4 Pin XLR Male Power Source/Charger
• 4 Pin Female Power Take Off. Can be used for devices without V-Mount Adapter.
Can also be used for Lights or Wireless Transmitters and Receivers.
• Durable enclosure
3
Electrical Specifi cations
Output Voltage 10 to 16.8VDC (Battery Dependent)
MAX Continuous Current Draw Up to 3 Ampere
PEAK Current Draw 4 Ampere
Charger Voltage 12 VDC
Charge Current Approx. 500 Milliamp to 2 Amp (Battery Dependent)
Charge Indications Three Color LED RED to GREEN illumination
Drain Indications >12 VDC, 11 to 12 VDC, 11 to 10 VDC from 3 Color LED
Low Power Indicator Flashing LED
Battery Type Sony NP-Fxx Type Lithium Ion
Output Voltage 10 to 16.8VDC (Battery Dependent)
4
General Information
Power required 12V D.C. from Universal Voltage Class 2 external supply
Dimensions 2.125”D x 5.0”H x 3.75”W (54mm x 127mm x 95.3mm)
Weight 0.75Lb (0.34kg)
Operating Temperature 14
̊ F to 140 ̊ F (-10 ̊ C to +60 ̊ C)
RoHS /Environmental Do not dispose. Return to Manufacturer or Authorized Recycle Facility
5
Optional Accessories
1. V-PS12-5V (XLR) - 12 VDC Power Source /Charger
2. V-XLR-B – Two foot long Power Tap Cable for monitors requiring Barrel or Bayonet Type connector
3. V-XLR-ConX – Two foot long Power Tap Cable for Marshall products using 2 Pin Female ConXal twist lock
4. Batteries – To Be Announced
6
Operational Setup
• Unpack the V-DV-PWR1 and physically inspect for any damage that may have occurred during shipping. Should
there be any damage, immediately contact Marshall Electronics at 800-800-6608. If you are not located within the
continental united states call [phone].
• Install batteries into mount clips
• Connect required cables for power charge or output.
• Turn on using rocker switch located on the side of the adapter. The LED will illuminate and fl ash when power is on
and current is being drawn. The LED will change color from Green to Yellow to Red as power is discharged.
• To charge, attach the V-PS12-5V (XLR) power supply to the female XLR connection. LED will illuminate Red,
Yellow, Green during charge
o Red = less than 10VDC available battery power
o Yellow = 11 to 10 VDC available battery power
o Green = Greater than 12 VDC available battery power
V-DV-PWR1