- Marshall LCD Panels Instruction Sheet

V-R63P-SDI Instruction Sheet
Marshall
http://www.LCDRacks.com e-mail: [e-mail]
Broadcast Multimedia Division
Side View
2.5”
Rear View
The operation of the V-R63P-SDI is fairly straightforward, however, please take note of the following:
1. The V-R63P-SDI has been designed to fit in a 3U space on your rack. It is important to use 4 screws to hold
the ears to the rack. Be certain that the ears are aligned vertically, this is important to the tilt function.
The V-R63P-SDI has a memory function that will remember the settings of each monitor including power and
channel selection even if power has been disconnected from the unit.
2. Each LCD Panel comes with a protective plastic film that must be removed by carefully lifting the film from
the corner and peeling it off. Be certain not to apply any pressure on the LCD panels, they are fragile and can
break. Scratched, cracked or broken LCD screens are not covered by our warranty.
3. The V-R63P-SDI uses 9VDC, 3.5 Amp regulated power. Be certain that these specifications are met when
using a power supply other than the one supplied to you by Marshall Electronics. The center pin on the coaxial
power connector for the V-R63P-SDI is the POSITIVE terminal and the outside ring is NEGATIVE. Any battery
operation of the V-R63P-SDI must have this polarity configuration.
4. The Video inputs on the rear of the panel are 75 Ohm self-terminated. The loop through feature uses active
components and is always active as long as power is supplied to the unit regardless of the monitor being On or
Off. The V-R63P-SDI is also equipped with a 10-bit D/A convertor that converts the SDI input from that channel.
This D/A convertor uses the SMPTE 259M standard and is reclocked.
The V-R63P-SDI is a rack mountable unit that has three independently controlled 5.8" active matrix LCD panels with
loop through capability. These 16:9 high-resolution panels have a pixel count of 1200 × 234, and are rated at a very
bright 350 candle luminance. Each panel has an SDI and a composite video input with an NTSC/PAL switch on the
back for each channel. Each of the three screens has a built-in color bar generator, controls for brightness, color, tint,
and contrast, and a selectable aspect ratio of 16:9 or 4:3. A built in 3 color tally system is also provided for each
screen. Unit comes complete with power supply, and fits into any standard EIA 19" rack, at only 3 rack spaces high.
5.8” LCD
Active Matrix
5.01” x 2.83”
each panel
0.318mm x
0.307mm
1200H x
234V
1 NTSC/PAL
1 SDI, per panel
Built into unit
19.125W x
5.14H x 2.5D
9 VDC
3.5 Amps
Display Viewing Area Dot Pitch Inputs Color Bars Dimensions
Picture
Elements
Power
Consumption