User Manual

3
The M-LYNX-702 V.3 monitor can be powered using either the included 12-Volt power supply
plugged into the small coaxial connector or standard 12-Volt camera-type power supply connected
to the 4-pin XLR connector. It is recommended to connect only one type of power supply at one
time.
The USB port is used for service functions only.
Connect a standard HDMI source here. For details, see the Compatible Input Formats section
below. Active loop out allows “daisy-chaining” to other devices. (Loop out continues to function
when the screen is turned off.)
Connect a serial digital source here. It is compatible with SDI, HD SDI, or 3G SDI sources. Active
loop out allows “daisy-chaining” to other devices. (Loop out continues to function when the screen
is turned off.)
The 15-pin D-Sub connector on the back panel is used to control the on-screen colored tally
indicators. The Red, Green, or Yellow border color can be turned on by connecting the appropriate
pin on this connector to the ground pin via “dry contact” or “open collector” type source. Refer to
the table printed next to the connector for wiring information. Note: External power should not be
applied to this connector.
Power Input
USB Port
HDMI Input and Loop Out
3G/SDI Input and Loop Out
TA LLY
2.2 Rear Panel Connections