User Manual

24
Use the TSL/MEI 422 setting to control OSD tally via the TSL or Marshall serial protocols.
■
IMD Baud Rate
Use this setting to choose the baud rate. The baud rate must be set in conjunction with the controlling device. Available
baud rates are 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200. The TSL v4.0 protocol is fixed at 38400
bauds for correct functionality, but this can be changed on the monitor for custom purposes.
■
IMD Name (S/N)
Use this setting to assign a name to each screen when using the Image Video or Marshall-IV protocols. The IMD name is
equivalent to the Image Video serial number and is used by the Image Video controlling device to identify each screen.
The default IMD Name(S/N) is “M00000.” It is recommended to maintain this naming scheme in order to avoid serial
number conflicts with other Image Video devices on the same serial bus. Each name can be up to 16 ASCII characters.
Press RotoMenu™ knob to edit the IMD Name. Rotate the RotoMenu™ knob to move the cursor. Press the RotoMenu™
knob with the cursor on the character to be changed, then rotate the knob to scroll through the character set . Press the
RotoMenu™ knob to choose a character.
■
IMD Tally Mode
Use this setting when using Image Video tally control. Choose one of the following settings, in conjunction with the Image
Video controlling device. T1, T2, T1T2, T2T1, T1-, T2-, T1T2-, T2T1-. Consult Image Video documentation for further
information.
IMD Fixed Config Submenu
IMD Fixed Configuration Submenu