Operating instructions

5
Installation and Initial Setup
■ Unpacking
Carefully unpack the V-R653-IMD-3GTE monitor and verify that the following items are included:
• V-R653-IMD-3GTE Monitor
• V-PS12-5V-1 DC Power Supply
• Operating Instructions
Inspect the unit for any physical damage that may have occurred during shipping. Should there be any damage, immediately
contact Marshall Electronics at [phone]. If you are not located within the continental United States, call +1 (310) 333-
0606.
■ Installation
The V-R653-IMD-3GTE can be mounted in any standard EIA 19” equipment rack. The attached rack ears can be angled to provide
the user control over the viewing angle. Adequate ventilation is required when installed to prevent possible damage to the
monitor’s internal components. Please see the Dimensions section for more information.
■ Connections, Power-On and Initial Setup
Plug the DC Power Supply into an AC power source (100-240 V @ 50/60 Hz). Attach the Power connector to the back of the
monitor. Connect the required cables for video signal input and output. (Power must be applied to the V-R653-IMD-3GTE for the
active loop-though output to be activated.) The monitor defaults to ‘ON’ when power is supplied. Video will automatically be
detected and displayed on the screen.