M S Y S T E BAS DYNAMIC HAND BOOK
ENGLISH FROM THE CHAIRMAN I would like to thank you personally for selecting one of our Dynamic Bass systems. My company has always been totally committed to the design and manufacture of the worlds finest amplification. We are well aware that catering for the constantly changing demands of musicians requires heavy investment into the research and development of new product ranges capable of meeting those demands. The new Marshall Dynamic Bass System comes as a direct result of that investment.
PLEASE READ THE FOLLOWING LIST CAREFULLY. A. ALWAYS fit a good quality mains plug conforming to the latest B.S.I. standards (UK only). B. ALWAYS wire the plug in accordance with the colour code attached to the mains lead (UK only). C. DO NOT attempt to remove the amplifier chassis. There are no user serviceable parts inside. D. ALWAYS have this equipment serviced or repaired by competent, qualified personnel. E. NEVER under any circumstances, operate the amplifier without an earth. F.
ENGLISH USING THE DYNAMIC BASS SYSTEM Make all the external connections such as the send (26) and return (27) to and from your effects processor, the output to your guitar tuner (25) and connection to the footswitch for the graphic EQ (20) if required. If you are extending the system by linking to a further D.B.S. amplifier, take a screened guitar cable from the link-out jack (22) of the controlling amplifier to the link-in jack (21) of the slave system.
proved to be the most effective for bass reproduction in our exhaustive listening tests. 13. Graphic EQ Master Level Master level slider offering + or - 6dB cut or boost (centre 0dB) of the overall graphic level. This allows the accurate balancing between the levels with or without the graphic switched in. 1. Hi-sensitivity Input Input for the connection of bass guitars with lower output levels. 2. Lo-sensitivity Input 14.
ENGLISH 23. D.I. Level Selection Switch 27. Effects Return Jack Selects 0dB or -20dB D.I. output levels for maximum interfacing flexibility. 24. Balanced D.I. Output For direct connection to recording or PA mixing desks and switchable pre or post EQ (16). The D.I. output is fully transformer isolated to guarantee against problems with earth loops and hence an earth lift switch is not required. Jack socket to accept the output from an external effects processor.
Front Panel 3 4 5 6 7 8 LO HI 9 10 11 12 50 S-SOLID STATE V-VALVE PEAK 80 160 320 640 13 1250 2500 5000 8000 +15dB BRIGHT . . . S V PRE-AMP BLEND GAIN . DEEP -15 . . +15 -15 . +15 LEVEL ON . ON 0dB . MIN MAX DEPTH PRIMARY EQ 15 +6dB THRESHOLD FLAT . 14 GRAPHIC -15dB COMPRESSION . -6dB GRAPHIC EQUALIZER . VOLUME POWER DYNAMICS BASS SYSTEM HI INPUT 1 PRE POST D.I.