37
38
39
The data can any alphanumerics of FULL ASCII Table (GROUP 34-42)(page 52-60) The data can any alphanumerics of FULL ASCII Table (GROUP 34-42)(page 52-60) 40
*The data can any alphanumerics of FULL ASCII Table (GROUP 34-42)(page 52-60) 41
42
43
44
45
46
47
48
49
GROUP-33 BULE TOOTH MODEL Connecting Multiple Handheld Barcode to a BT Bluetooth Adapter The Quick Guide describes the steps to connect Handheld Barcode scanner to Bluetooth adapter. Other Bluetooth adapters may have similar installation steps. Please read the user manual before you setup Hand-held barcode scanner and Bluetooth adapter.
GROUP-33 BULE TOOTH MODEL Setting up Barcode Scanner with Bluetooth Adapter (Dongle) 1. “Right Click” on the Bluetooth icon in the System Tray . . Then select option “Add new Bluetooth hardware.” 2. Go to next page and find the “Disconnect BT” label on the bottom of the page. 3. While the Bluetooth setup wizard is searching for Bluetooth devices, click on the trigger of the scanner to activate the connection. Scan the “Disconnect BT” barcode to complete the search. 4.
POWER MANAGEMENT MODE . B017$ 1 MINUTE . B019$ 5 MINUTES . B018$ 3 MINUTES .
52
53
54
55
56
57
58
59
60
61
62
( ) ( ) ( ) ( ) ( ) ( ) ( ) ┐ £ " # " # ! " # " # ! # # "
64
65
66
APPENDIX 1 DEFAULT TABLE 1 CROUP 1 2 3 PARAMETER DEFAULT Computer Type PC-AT Interfaces * Reading Mode Trigger Beep Tone Mode 2.1k 1.Beep Medium Beep Tone Mode 2.7k 1.Beep Medium Capital lock Mode 3.
APPENDIX 1 DEFAULT TABLE 2 CROUP PARAMETER DEFAULT UK Plesssy 18 2 1 19 2 3 1 20 2 1 21 2 22 1 1 23 2 24 25 Enable/Disable Disable Check Digits CDV & not send CD IATA Enable/ Disable Check Digits Min Length Max Length Code 93 Enable/Disable Min Length Max Length Telepen Enable/Disable Telepen ASCII /Number Interlenved 2 of 5 Enable/Disable Check Digits First/ last digit suppressed Min Length Max Length Code II Enable/Disable Check Digits Min Length Max Length Industrial 2 of 5 Enable/Di
APPENDIX 1 DEFAULT TABLE 3 CROUP PARAMETER DEFAULT UPC-E 26 Enable/Disable Enable Check Digits Send Lead Digits Send Add a space Off Addenda required Off +5 On/Off Off +2 On/Off Off UPC-A&E, EANS Expand, UPCE systems number 27 UPC E(0) On/Off On UPC E(1) On/Off Off UPC-E expand to UPGA Disable UPC-A expand to EAN13 Disable UPC-A 28 Enable/Disable Enable Check Digits Send Lead Digits Send Add a space Off Addenda required Off +5 On/Off Off +2 On/Off Off EAN-8 29 E
Appendix 2 70
71
Appendix 3 BAR CODE TEST CHART DENSITY NARROW mm(mil) WIDE mm(mil) CHAR.GAP mm(mil) N/W RATIO MEDIUM DENSITY 0.25(10) 0.625(25) 0.25(10) 1/2.
Appendix 3 BAR CODE TEST CHART 73
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.