Instructions / Assembly

ManualsBrandsMartha Stewart Living ManualsOutdoorsLake Adela Charcoal 5-Piece Patio Dining Set with Cilantro Cushions

LAKE ADELA ROUND

WOVEN

DINING TABLE

Please read over this instruction manual as it will save time in the

assembly of this product.

Note: Prior to assembly, please open and lay parts out on a clean, soft

flat surface to avoid any damages to the product’s finish.

HDC#:1928710829 MFG#:FRA60408A-ST-CH

Summary of content (8 pages)

PAGE 1
LAKE ADELA ROUND WOVEN DINING TABLE HDC#:1928710829 MFG#:FRA60408A-ST-CH Please read over this instruction manual as it will save time in the assembly of this product. Note: Prior to assembly, please open and lay parts out on a clean, soft flat surface to avoid any damages to the product’s finish.
PAGE 2
Caution: The Lake Adela Dining Round table was made for the explicit purpose of providing outdoor functions and is not to be used as a toy. This product is not intended for Inclement /Severe weather in any form including, but not limited to: rain, hail, sleet, snow and/or wind. Manufacturer recommends that with formidable weather approaching you store and/or cover this table. Do not locate structure near any open flame. Do not use structure as a support. Do not shake, lean or climb on structure.
PAGE 3
DO NOT RETURN TO RETAILER IF YOU HAVE ANY QUESTIONS OR CONCERNS PLEASE VISIT OUR WEBSITE AT: www.yotrioint.com OR TOLL FREE AT: 1-800-245-2217 MONDAY-FRIDAY 8:30 AM TO 5:00 PM PACIFIC STANDARD TIME / 11:30 AM TO 8:00PM EASTERN STANDARD TIME Warranty Coverage Requirements: 1. Copy of your Original Store Receipt. 2. Pictures of the damaged parts. 3. You must know the name of your product and any corresponding item numbers as well as the name of the store where you purchased the item. 4.
PAGE 4
Parts Check List Please remove all parts carefully from box and lay out on clean, soft surface to protect product’s finish.
PAGE 5
A. M6X15 Bolt – 16PCS C. M6 Washer – 32PCS ‘ B. M6X25 Bolt – 16PCS D.
PAGE 6
1. Attach the table leg (2) to the skirt (3) using M6x25 bolts (B) and M6 washers (C). Use the hex wrench (D) to loosely tighten all the bolts. Repeat this step for the other table legs.
PAGE 7
2. Lay the table top (3) upside down on a soft surface. Connect the table leg (2) to the table top (3) using M6x15 bolts (A) and M6 washers (C). Use the hex wrench (D) to loosely tighten all the bolts. Repeat this step for the other table legs.
PAGE 8
3. Once all the bolts are in place. Fully tighten all the bolts with the hex wrench (D). Turn the table right side up. Check to ensure the table is tightly assembled and stable before use.