User's Manual

notifications” at the bottom of this tab, you can then change the filter
settings and create customized vibration patterns for those also. You can
receive notifications on your watch from all apps you have installed that
allow push notifications.
Note: An app must be installed on your phone for you to be able to receive
notifications from that app. See “RECEIVING INCOMING NOTIFICATIONS”
section for instructions.
Setting Alert Filters – Here you can choose which alerts from your phone
that you want to have forwarded to your watch. Tap on the box next to each
notification icon to check On. To turn Off the notification, simply tap on the
same box to uncheck.
Customizing Vibration Patterns – Custom vibration patterns allow you to
discern the difference between alerts even without looking at your watch.
Each pattern uses up to four placeholders, with each placeholder able to
trigger a Short, Long, or Pause signal to create a pattern.
Martian has established general default patterns to give you a start in
setting your own patterns.
To further customize these settings:
Tap on the app name for which you want to create a custom pattern.
Choose a pattern up to 4 characters long. Use “Pause” if you want a pause
during the pattern. For example, choose “Short Pause Long Short” and your
vibration pattern will be “short-pause-long-short”. “Short Short Pause Pause”
will be short-short.
Test your pattern after you set it up by holding your watch and tapping
“Test” on the App.
When you are satisfied with the pattern you created, tap “Set”.
Repeater Tab
Hour Repeater – This feature sends a double-vibration alert to your watch
at a given minute of every hour during the range of hours you select. For
example, you might have choose to have an alert titled “Stretch!” sent 5
minutes before every hour between 9 am and 4 pm. To set up your Hour
Repeater, tap on the box next to “Enable hour repeater” and then:
Set minute – Choose “set minute” of each hour when you want to receive an
alert (for example, if you choose “35”, you will receive an alert at 1:35, 2:35,
3:35, etc).
Active from – Choose the time when you want the repeater to begin.
Active to – Choose the time when you want the repeater to end (note: if you
choose “35” and a 6:00pm end time, your last alert will be at 5:35pm).
Set Label – Tap to give your repeater a name that will display on your
watch’s display screen, such as “Break Time”.
Tap “Save” to save and return to the Home screen.
Alarms Tab
Silent Alarms – You can create up to 5 silent alarms, each with its own