User's Manual

your watch. Then, press and hold both buttons on!the watch until the word
“Restored” appears.
!
Troubleshooting
Martian Notifier turns off unprompted:
– The battery level is too low. Charge your battery.
– Pairing has failed. Follow instructions to turn on and pair your Martian.
Red battery LED light!doesnʼt!turn on when watch is plugged in to
charger:
Make sure you use the micro-USB cable that came with your Martian Notifier,
as it has a longer connector than most other cables. Confirm that the
connector is securely seated in the watch’s port, and the USB adapter is
connected to a working power outlet or the USB port of a computer that is
charged and turned on.
Watch doesnʼt reconnect to phone after returning into range:
– Verify you are in range by pressing the bottom button to view the status
bar – the Bluetooth icon will appear if the watch is in range of the phone.
Note: Solid obstacles reduce the range of the watch, and some phone
cases reduce the phone’s Bluetooth range.
– Check to see if your watch has disconnected from your phone. If so, re-
pair the watch to your phone following instructions in the Pairing section
above.
Your Bluetooth 3.0 +HS (high speed) device doesnʼt work with your
Martian Notifier:
Your Bluetooth 3.0 device may not be compatible with non-WiFi devices –
MARTIAN WATCHES don’t support HS.
You are standing in an open area like a parking lot, or you have your
phone in your back pants pocket, and you receive an “out of range”
message from your Martian Notifier:
Open fields and “body loss” are the two main causes of reduced Bluetooth
range between your!Martian Notifier and cell phone. If in an open area, move
closer to an object such as a car or building, and reception will improve. If
your phone is in your back pocket, try turning your phone upside-down,
move it to the opposite side, or put it in your front pocket –any of these will
likely improve your connection.
Your OLED display isnʼt displaying a message, but the LED and
vibration are alerting you that you have incoming notifications:
Plug in your USB cable to the watch, then quickly remove it. This resets the
software and should resolve your problem.
You short-press the top button on your Martian Notifier to activate the
voice feature but it doesnʼt start and you donʼt see the green blinking
light:
You cannot initiate a voice command while a notification is scrolling on your