User`s guide

4 INTRODUCTION

Thank you for purchasing a Martin Audio AQX controller. The AQX

controller is used to optimise the performance of the AQ series of

loudspeakers in all modes of operation. A universal plug-in card is fitted

which provides crossover filtering and EQ settings for all combinations of

AQ series loudspeakers.

5 UNPACKING

Each Martin Audio AQX controller is built and tested to the highest

standards and thoroughly inspected before it leaves the factory. After

unpacking the unit, please examine it carefully for any signs of transit

damage and inform your dealer if any such damage is found. It is

suggested that you retain the original packaging so that the unit can be

repacked at a future date if necessary.

Please note that Martin Audio and its distributors cannot accept

responsibility for damage to any returned product through the use of

none-approved packaging.

6 INSTALLATION

The AQX requires a vertical rack space of 1U (1.75"/44 mm). As with any

low level signal processing equipment it is recommended that it is sighted

well away from any high level sources of electromagnetic radiation, and

should not for example be placed directly above power amplifiers or lighting

dimmers, which could induce residual noise into the system.

7 MAINS CONNECTIONS

The AQX is supplied as standard with a captive mains lead with an integral

U.K. 3 pin plug.

Should the moulded plug be removed and another plug substituted the

cable must be re-wired as below.

GREEN/YELLOW - EARTH

BROWN - LIVE (+)

BLUE - NEUTRAL (-)

Martin Audio – AQX Controller

ENGLISH

CONTENTS