Technical data

20 E1300 TECHNICAL SPECIFICATION
INPUT IMPEDANCE 20K Ohms differential, 10K Ohms single ended
INPUT SENSITIVITY Selectable 0.775mv (36dB gain) or 1.23V
(32dB gain)
FREQUENCY RESPONSE 17Hz - 46KHz + 0dB – 3dB
POWER BANDWIDTH 10Hz - 40KHz + 0dB – 0.5dB
POWER OUTPUT 400 Watts Cont Av into 8 Ohms
720 Watts Cont Av into 4 Ohms
1000 Watts Cont Av into 2 Ohms
1440 Watts Cont Av bridged into 8 Ohms
OUTPUTS
Impedance 22mΩ
DC offset <2mV
SLEW RATE 70 Volts per micro second
(SIGNAL + NOISE) / NOISE >100dB 20Hz - 20KHz IEC, A weighted
RATIO
DISTORTION < 0.06% @ 1dB below full power
POWER REQUIREMENTS 230V Setting 115V Setting
Operating voltage 180* – 250Vac 90* - 125Vac
Minimum start-up voltage 140Vac 70Vac
Peak inrush current 11.8 Amps 23 Amps
Current draw 4Ω
Quiescent (No load) 0.9 Arms 1.8 Arms
1/8 Full power (Both channels) 4.8 Arms 9.6 Arms
1/3 Full power (Both channels) 7.2 Arms 14 Arms
Dual voltage operation 115V or 230V
(internal Links).
*Note: The amplifier will operate down to the indicated mains voltage but with
reduced power output.
AMBIENT TEMPERATURE Maximum ambient operating temperature +40°C
INDICATORS Power On, Signal Level, Bridge, Thermal,
Card/Module Enable
INPUT CONNECTIONS 2 x XLR with 2 x XLR parallel links
Pin 2 Hot, Pin 3 Cold
Martin Audio – E1300 Amplifier
ENGLISH
22
All material © 2007. Martin Audio Ltd. Subject to change without notice.
CONTENTS
PRINT
<
>
GUIDES