Specifications

1 INTRODUCTION

Thank you for purchasing a Martin Audio EMX Series system controller.

EMX controllers are used to optimise the performance of Martin EM Series

loudspeaker systems in all modes of operation - whether full-range or with

additional sub-bass. The EMX1A is dedicated to all the EM Range,

including the EM201 and EM251 sub-bass systems, (apart from the EM186

which has its own controller).

2 UNPACKING

Each Martin EMX controller is built to the highest standard and thoroughly

inspected before it leaves the factory. After unpacking the unit, examine it

carefully for any signs of transit damage and inform your dealer if any such

damage is found. It is suggested that you retain the original packaging so

that the unit can be repacked at a future date if necessary.

Please note that Martin Audio and its distributors cannot accept

responsibility for damage to any returned product through the use of non-

approved packaging.

3 MAINS CONNECTION

The EMX1A is provided with an IEC 320 type mains receptacle. It is

supplied with a 2m mains lead terminated with a standard IEC 320 plug,

which must be connected as below:

GREEN/YELLOW - EARTH • BROWN - LIVE • BLUE - NEUTRAL

Mains voltage tolerance ± 10% on each setting.

Fuses type T semi delay 100-120V 500mA(L), 220-240V 250mA(L)

ARNING: The EMX1A controller must always be operated with the

mains safety earth connected.

Martin Audio – EMX1A System Controller

ENGLISH

This equipment must be earthed.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

DO NOT EXPOSE TO RAIN

OR MOISTURE

It should not be necessary to remove any protective earth or signal cable

shield connections.

This equipment conforms to the requirements of the

EMC Directive 89/336/EEC, amended by 92/31/EEC

and 93/68/EEC and the requirements of the Low

Voltage Directive 73/23/EEC, amended by 93/68/EEC.

Standards Applied EMC Emission EN55103-1:1996

Immunity EN55103-2:1996

Electrical Safety EN60065:1998

CONTENTS

GUIDES