Specifications
5 CONTROLS
5.1 Mode Switch
This is mounted internally on the plug-in board and allows the unit when
appropriate, to be switched from 3-way to 4-way operation.
In 3-way mode the (‘mid’) output will function up to the upper bandpass
filter or as defined by system parameters, band 4 (’high’) remains available
and may be used for driving additional VHF units in ‘overlap’ mode.
5.2 Level Controls
Each frequency bands level can be adjusted over a 12dB range from
-6dB to +6dB relative to its nominal level to allow the user to precisely
balance each level with respect to each other.
5.3 Limiters
Each output is fitted with a limiter which provides momentary gain reduction
when the signal level exceeds a preset threshold value. A red LED
indicates the onset of limiting.
Threshold settings for the limiters may be adjusted by first removing the
MX5 top cover (two screws on each side) to gain access to the 16 way
switches which are located on the main motherboard. Setting the limiter
threshold automatically sets the range of the LED display which will indicate
dB’s below threshold.
Threshold values corresponding to the switch positions are printed on the
main motherboard reproduced here for your information.
01 23 45 6 789A BCDEF
0.2 0.4 0.5 0.7 0.9 1.1 1.3 1.4 1.6 1.8 2.0 2.2 2.3 2.5 2.7 2.9
Each channel limiter sets a maximum drive level from the MX5, which in
turn sets the maximum continuous voltage that the amplifier can present to
its load.
The plug-in top board has pre-set time constants that optimise the limiters
for each frequency band.
The limiters in the MX5 may be used to control the average continuous
power applied to the loudspeakers, if power amplifiers with a higher
maximum power rating than that recommended are used. (See Amplifier
section) Alternatively, if the loudspeakers selected will handle the full rated
power, or if maximum system headroom is required, the limiters may be set
to prevent the amplifiers being driven into hard clipping.
Martin Audio – MX5 System Controller
ENGLISH
8
All material © 2007. Martin Audio Ltd. Subject to change without notice.
CONTENTS
<
>
PRINT
GUIDES