Specifications

If the required lifting point is too far back, make sure the lifting bar is in the rear position

and that the cabinet is mounted at the front of the grid before trying an alternative

height. Similarly, if the required lifting point is too far forward, make sure the lifting

bar is in the front position and the cabinet is mounted at the rear of the grid before

trying an alternative height.

Adjusting the array height slightly on the Venue page will often position the system on

a suitable hole or narrow the gap between the required angle and the angle given by

the nearest hole. Flip between Venue and Array views to set and recheck.

Slight difference between required tilt and tilt given by nearest

lifting bar hole

Alternatively, you may click on the Apply button (circled). This applies the actual

angle (±0.1°) given by the nearest lifting bar hole to the design by switching ViewPoint

to Manual mode. Check that coverage start is met (Venue view) before accepting this.

Two Point Lift

This places a pick point at each end of the bar.

A two -motor lift from a lifting bar will…

Enable more extreme up-tilts and down-tilts because the lifting bar extends

beyond the front lifting point forward of the normal grid tab in the front

position and extends the rear lifting point behind the normal grid tab in the rear

position

Spread the array load across two rigging points

Allow fine angular control using the motors