Specifications

When designing ground-stacked arrays, inspect the array view and check that the

center of gravity is in a safe place.

Stack stability

Red stability limits are indicated within the grid on the Array page – circled on the

right below.

If the centre of gravity crosses this red region the force required to push or pull the

array over is less than that shown in the box beside the array view and a mechanical

warning is raised.

Please note: This assumes that no sliding takes place. Grids should be securely

attached to the ground in all cases.

The push value (in Newtons) – shown circled on the left below - can be varied to

simulate wind load.

Zoom In

This shows the ground-stack bar position required for the lowest cabinet angle.

CONTENTS

GUIDES

ENGLISH ONLY