Manual

Control settings 13
Control settings
Overview
The digital display in the centre of the top panel allows you to configure the
machine using option menus.
The machine is factory set so the lower of the ‘Value down/up’
b
uttons
increases a setting. It is possible to change this. Prior to powering the
machine up simply press and hold the button you wish to use to
increase a setting and press the main power button. Once the display
comes on you have successfully configured your preference. The
machine will store this setting until the above procedure is performed
again.
Setting Run mode
The Run mode sets the operational mode of the unit, either Off, Standby (heaters
remain on), Fan only, Timer mode or Continuous mode.
Use the Menu Previous / Next buttons to select the  option.
Use the Up/Down buttons to select .
Press the Enter button to store the setting. The display shows .
Selecting OFF will cause the machine to begin its cleaning cycle ready for power
off, if cleaning is required. This is the same as pressing the Shutdown button on
the rear.
Setting Haze density
Use the Menu Previous / Next buttons to select the  option.
Use the Up/Down buttons to select the density from  – .
Press the Enter button to store the haze setting. The display shows .
If you want to temporarily change the haze density, do not press Enter.
The haze setting will go back to its stored value next time the machine
is powered up. This applies to all options.
Menu previous/next
buttons
Value down/up
buttons
Digital displa
y
Enter/store button
