Manual
Control settings 15
Setting the master-slave link mode
It is possible to control several machines from one digital remote. The machine
with the remote plugged into it becomes the Master. The other machines are
Slaves. The machines are interconnected with DMX cabling.
Use the Previous / Next buttons to select the option.
Use the Up/Down buttons to select (slave unit) or (master unit).
Press the Enter button to store the link setting.
The machine should be set to only if it is running as a master. If running
as a slave, stand-alone or DMX controlled it should be set to .
Alt option
This option is not currently used and has no effect on the machine.
Priming the machine after fluid out
If the machine runs out of fluid it should be shut down to prevent damage to the
pump. To suck the new fluid back into the machine, replace/refill the fluid tank
and use the prime function.
Use the Previous / Next buttons to select the option.
Use the Up/Down buttons to change the option to .
Press the Enter button to start the priming function.
The machine will pump at full power for about 10 seconds or until the unit senses
fluid in the heat exchanger.
To exit this menu if you decide not to activate the Prime function, select and
press Enter.
If the machine is not up to operating temperature the Prime function will do
nothing.
Resetting options to factory settings
The factory settings configure a standard mode of operation for the machine.
Use the Previous / Next buttons to select the option.
Use the Up/Down buttons to change the option to .
Press the Enter button to reset all options.
To exit this menu if you decide not to reset the options, select and press Enter.
The factory settings are:
option setting
HAZE
FAN
TRUN seconds
TOFFseconds
RUN