Manual

Quick Start 9
Quick Start
You are no doubt eager to switch on the machine and try it out by making a lot of
haze. This section tells you how to do that. However, please also make the time
to read the safety and servicing instructions in the remainder of this manual.
Setting up
Locate the machine in a suitably large area with nothing in front of the haze
output.
Fill the fluid tank with Martin C-Plus Haze Fluid™ only. Use of other fluid will
void the warranty.
Connect a suitably rated power supply to the machine using the supplied Neutrik
Powercon cable. The power requirements are:
4.4A @ 230V (EU model)
8.68A @ 120V (US model)
Now set the mains switch, at the rear of the machine, to the ‘ON’ position. Select
STBY from the RUN menu. The display will show HEAT, then after about 60
seconds the display will show RDY and the machine is ready to produce haze.
Making haze
Press the Menu < > buttons until the display shows RUN, then press the Value
Up/Down buttons to select CONT (continuous). Press Enter.
If no haze is output or you want to change the haze density, press the Menu < >
buttons until the display shows HAZE, then press the Enter button and check that
the HAZE setting is above 0%. If not, use the Value up/down buttons to select a
value above 0%.
You can also adjust the fan speed using the FAN menu.
If no haze is produced it may be necessary to prime the machine,
press the Menu <> buttons until the display shows PRME, then press
the Value Up button so the display shows Y, then press the Enter
button.
Switching off
The Compact Hazer is designed to run a self-cleaning cycle before power down
to help prevent blockages. Before disconnecting the power, you should start the
cleaning cycle by pressing the Shutdown Switch on the rear of the unit above the
DMX connectors. The red LED in the shutdown switch will be lit if a cleaning
cycle is needed.
If cleaning is needed, the display will show “WAIT”, then “WT44” counting down
to “WT00”. When the display shows “OFF” the power may be turned off.
Do not turn off the power without using the Shutdown switch. This will
cause the unit to enter a cleaning cycle when next switched on, and
over time will lead to blockages and malfunction of the unit.