Owner manual

ManualsBrandsMartin Christ ManualsEquipmentGamma 2-16 LSCplus

Gamma 1-16 LSC&

Gamma 2-16 LSC&

3 Safety

Version 04/2013, Rev. 1.1 of 16/12/2013 • sb

Translation of the original operating manual

Pos: 56 / 200 Christ /36 0 GT -BA La bor-P ilot (S TA NDA RDMOD ULE) /03 0 Si cher heit/ 030 -00 60 Sic her heitshi nwei se +++++ ++ +++++ ++++ +++ ++++ ++ ++++ @ 5\m od_ 1299136 463 260 _68. docx @ 34 708 @ 2 @ 1



3.6 Safety instructions

The following instructions must be observed prior to every drying process:

WARNING

• Ensure that the freeze-dryer was set up and connected properly (see

chapter 5 - "Set-up and connection").

• Maintain a safety distance of at least 30 cm (12 inches) around the

freeze-dryer.

• Do not store any dangerous goods in the safety area of the freeze-

dryer.

• Do not stay in the safety area longer than what is absolutely necessary

for the operation of the freeze-dryer.

• Only use accessories that have been approved by the manufacturer

(except for commercial vessels made of glass or synthetic materials).

We explicitly warn against the use of equipment of poor quality.

Breaking glass or bursting vessels can cause dangerous situations.

• Observe the instructions on the installation of accessories (see the

separate document).

Pos: 57 /010 Unive rsalm odule/ L ee rzeile @ 0\ mod _120211 624450 0_0.docx @ 11 4 @ @ 1

Pos: 58 / 200 Chris t /36 0 GT-B A La bor -Pi lot (S TA NDA RDMOD ULE) /03 0 S icher heit/ 030 -00 60- 001 0 Elekt ri sche Si cher heit @ 5\ mod _12 9913 646365 0_6 8.do cx @ 3 4716 @ 3 @ 1



3.6.1 Electrical safety

CHRIST freeze-dryers are units of safety class I. Please comply with the

following points in order to preserve the safety features:

DANGER

• Ensure that the local mains voltage matches the nominal voltage that is

stated on the name plate.

• Do not place any dangerous material, e.g. glass vessels containing

liquid substances, within the safety area of 30 cm around the freeze-

dryer. Spilled liquids may get into the freeze-dryer and damage the

electrical or mechanical components.

• Work on the power supply system must only be performed by certified

electricians.

• Inspect the electrical equipment of the unit regularly. Defects such as

loose or burnt cables must be eliminated immediately.

Pos: 59 /010 Unive rsalm odule/ Seit enwec hsel @ 0\m od_120 2116244 312_0. docx @ 105 @ @ 1