User`s guide

Heave out the sail in vertical direction -by

tightening the rope between the boom and the

mast. Fix the taut rope in the jam.

Lace the foresheets through the grommets on

the frame and tie a knot to prevent them from

pulling out.

Mount the rudder. Attach the rudder assembly

to the frame simply by running two spigots with

safety locks.

Now run the main foresheet rope through the

pulley in the rear corner of the sail and secure it

in a notch on the tiller.

Now you can erect the mast. By tightening the

front rope and locking it in the notch you can

achieve thorough tautening for all the ropes

and the mast. Screw in the stretchers on the

lower stainless ropes in such a manner so that

these are tautened.

Unpack the jib and to its top fix the lifting rope.

Then pull up the jib and its bottom corner with

the jib furler fix with a carbine as shown on the

photo below. Roll out the mainsail and attach

the lifting rope running from the top of the mast

to it. Insert the sail in the notch in the mast and

pull the lifting rope to lift it up. Then tie up the

rope to the sling on the mast.

Lifting

ropes

Main Sail

Jib