Owner`s manual

Martin Innovations 16
7 Heel Loop Installation/Removal
1) Pull the cam lever into the up or “unlocked” position.
2) Push in the release button and remove the bottom footrest assembly from
the upper support.
3) Remove the mounting screw, spacer and locknut that secure the existing
heel loop to the footrest.
4) Slide the existing heel loop off the lower footrest assembly.
5) Slide the new heel strap onto the lower footrest assembly.
6) Reverse steps 1-4 to reassemble the footrest.
7) When securing the heel loop to the footrest assembly, tighten the
mounting screw and locknut until the spacer is secure.
WARNING
After adjustments, service or repair, make sure attaching hardware is
securely tightened. Otherwise, injury or damage may occur.