Operating Instructions

BDA Captura 100 MIFARE® / 2020-10-26 (GB)
10
GETTING STARTED AND CHANGING BATTERIES
1. Opening the cover of the baery compartment by
loosening the screw.
2. Insert the baery. Pay aenon to the correct
polarity of the baery. A long acousc and an
opcal signal are provided.
3. Then close the baery compartment cover
and hand-ghten the screw.
CAUTION: Use only a CR123A primary-baery.
Insert the baery aer installing
the lock in the furniture.

Baery is inserted correctly in the baery
compartment.

Quick ashing
Short ashing
Long ashing

Short
Long
The RFID antenna is located on the back of the
lock. Always place the transponder straight and
centered on the lock.
TIPS FOR THE FOLLOWING PROGRAMMING STEPS
The last 5 seconds before the shutdown of the
programming process are announced by the
ashing of a yellow lamp and acousc signals.
Opcal signals are only available aer mounng
the oponal lightpoint. The visual and
acousc signals are dierenated as follows.