Operating Instructions

BDA Captura 100 MIFARE® / 2020-10-26 (GB)
17

Hold the master card
in front of the lock.
Hold the programming
card “P3: Reset“
in front of the lock.
Hold the programming
card “P3: Reset“
in front of the lock again.
Hold the master card
in front of the lock.
aer about 10 seconds
ACTIVATION AND DEACTIVATION OF AUTOMATIC LOCKING
With the programming card “P4: Auto Locking”, the funcon “automac locking“ can be acvated and deacvated in
the operang mode “assigned use“. Once the funcon is acvated, the lock closes automacally aer 5 seconds aer
opening the lock with an authorized transponder. It is recommended to acvate “automac locking“ aer programming
the transponders.
The funcon can be carried out by using the master card and the programming card “P4: Auto Locking”. To do this,
the lock must be in the mode “assigned use“ and in an open posion. If the operang mode changes, this funcon is
automacally deacvated. The programming card must be purchased separately from LEHMANN Vertriebsgesellscha
mbH & Co. KG. The card can be used universally.

Hold the master card
in front of the lock.
connue on page 18
NOTE: If the funcon „automac locking“ is acvated, hold the master card in front of the lock immediately aer
opening in order to start the programming. Otherwise, the lock will lock automacally aer 5 seconds.
The lock must be in an open posion for programming incl. programming user cards.