Operating Instructions

BDA Captura 100 MIFARE® / 2020-10-26 (GB)
2
GENERAL DESCRIPTION
The Captura 100 MIFARE® lock is a baery-operated electronic furniture lock based on RFID technology, which is
intended for use in living and oce areas inside buildings. These operang instrucons provide you with informaon
on how to operate the locking system without errors. Keep the operang instrucons in an easily accessible place.
Improper use can destroy the locking system and lead to the loss of any warranty claims.
Please be sure to observe all warnings and read the operang instrucons completely before proceeding with
installaon, commissioning and programming. It may be possible to use our locks and locking systems together with
mechanisms made by other manufacturers, but their compability must be checked in each individual case. We
cannot accept any liability for damage or loss due to incompability.
Wording and graphics have been prepared with care. However, no liability will be assumed for any mistakes that may
have occurred. Technical specicaons as well as the scope of items in the system are subject to change without
noce.
CAUTION: The lock can be congured with master and programming cards or with the LEHMANN Management
Soware LMS. These operang instrucons describe how to use the locking system with master and
programming cards. The soware LMS and the corresponding documents can be found at hps://
lms.lehmann-locks.com.
SAFETY PRECAUTIONS
UU Pack the baery for the transport of the lock so that no short circuit can occur (risk of explosion and re).
UU When replacing the baery, make sure that the polarity and posion of the baery is correct!
UU Dispose of used baeries properly!
UU Do not heat baeries, take them apart or short-circuit them!
UU Never throw baeries into open re!
!
TECHNICAL SPECIFICATIONS
Frequency
13,56 MHz
Naonal legislaon about permissible radio frequencies must be observed.
RFID technology
MIFARE® Classic, MIFARE® DESFire® EV1, EV2
Supported
transponders
Compable with the following RFID transponders:
• MIFARE® Classic / • MIFARE® DESFire® / • ISO 14443A
Exisng transponders must be checked for compability!
Energy supply
1 x CR123A

-5 °C to +60 °C

-25 °C to +70 °C
Reading distance
Up to 30 mm with LEHMANN user cards (MIFARE® DESFire® EV1). Other transponders
may have a shorter reading distance and must be checked in advance. The material of the
furniture can inuence the reading distance. A test on the furniture regarding the reading
distance is therefore recommended.

L3NF13CX