Operating Instructions
BDA Captura 100 MIFARE® / 2020-10-26 (GB)
9
All dimensions in mm.
MOUNTING ON METAL SURFACES
When installing the lock on metall surfaces, the cover C1 for metall surfaces is required. The separate lightpoint is
not required because a lightpoint is already integrated in the cover. Only suitable for single-layer steel doors with a
thickness of 0.5 - 2.5 mm.
16
61
)(7
Mittelpunkt für Schließdorn
R
3
23,5
Angedeutete Dome Frontco
ver
RÜT
WNET
IES
m( DNA
O ti
)nrodßeilhcS dnu agem
13,5
Door
Implied screw-on
socket
Center point for
locking pin
Required hole punch in the door
Hole punch in the door
Side wall with locking pin
SD Type A
13,5
5,2
4x Thermoplasc
screw 3x25
ATTENTION: If no lightpoint is installed, a scker is recommended on the outside of the door, centered behind the
lock, for correct posioning of the RFID transponder.
Using the LEHMANN RFID scker:
1) Remove the backing paper.
2) Sck the self-adhesive transfer lm with the RFID symbol
on the outside of the door, centered behind the lock.
3) Carefully pull o the transfer lm so that only the
RFID symbol scks to the door.